Cutting Thick Substrates on the Evolution/Evolution-E2

The Evolution-E2 Precision Cutter can cut up to 1/2″ (13mm) thick substrates.  When cutting these thicker materials it is important to remember to adjust the Black Level Adjustment Knobs located on the end of each side.

Place the material under the cutter bar and release both Adjustment Knobs.  The cutter bar will settle to the surface of the material.  Raise the cutter bar using the lift handle and lower again to ensure correct alignment and tighten both Adjustment Knobs.

When you are cutting a small piece from a thicker substrate, place it at right hand end of the Cutter Bar against the Horizontal Flip Stop and place a scrap of the same thickness material under the remaining bar to support it and prevent sagging.

For more information please visit www.fosterkeencut.com